Stable Range
Width x Length
Standard Loose Boxes are available in single or multiple configurations in the following sizes – Horse 3.6m x 3.6m Hunter 4.2m x 3.6m
Height
Height to eaves 2250mm, overall height to ridge 2768mm, this height does not include the single brick course.
Cladding
High quality, pressure treated exterior shiplap T&G boards 16mm x 125mm nominal, planed.
Framing
2” (50mm) x 3” (75mm) prepared graded timber, spaced at approximately 24” (600mm) centres.
Roof Purlins
50mm x 100mm prepared, selected, graded timber spaced at approximately 600mm, held in position with steel joist supports, fitted to 50mm x 75mm prefabricated timber apex frames.
Roof Cladding
Black, Red, Green or brown Onduline corrugated roof sheets are used as standard which comes with a 15 year guarantee. Translucent sheeting is available on request.
Canopies
Canopies extend to 900mm and are lined with 6mm WBP Ply.
Kickboards
We only use high grade 9mm exterior ply which is fitted to 1.2m height.
Gable Ends & Ventilation
All gable end roofs are finished with pressure treated barge boards and louvered ventilators are fitted, increasing air flow and preventing wind driven rain entering loose boxes.
Stable Doors
Our standard doors are 1219mm wide and 2082mm high. Frames are constructed with a sturdy 50mm x 50mm timber, the main body of the doors are built in tanalised, pressure treated shiplap T&G boards 19mm x 125mm on the exterior and lined top and bottom with high grade 12mm exterior ply kick board to the inside face.
We fix heavy duty galvanised 30” reversible hinges, 10” Brenton bolts, 10” cabin hooks to top doors and reversible kick-over bolts are fitted as standard. Galvanised. Chew strips are fitted to the top edge of the bottom door, the door meet can be angled to discourage wind sucking.
Stable Windows
645mm x 645mm (2’ x 2’) fitted with non-breakable Perspex and weld mesh grills. Hopper style windows are available on request.
Gutters and Down Pipes
Guttering and down pipes are fitted to the front and rear of units.
Stable Partitioning
2235mm high x 3500mm wide, 50mm x 75mm prepared graded timber, spaced at approximately 609mm centres with 9mm exterior grade ply.
Recommended Base Preparation
We would recommend that if you have a relatively flat base drainage channels are not necessary, a gentle gradient, 1” higher at the back of the stable sloping to the front is usually sufficient.
6” of compacted hardcore is recommended under a 4”-6” concrete base, ideally the concrete should be mixed with an acid inhibitor, the code for this is RC45. Usually there is a minimum 3’-4’ concrete frontage to the stable area, although this is a matter of personal preference.
Internal Stable Grilles (optional)
Heavy duty, hot dip galvanized internal divider grilles are strongly constructed from 25mm x 25mm wide box section steel with 10mm diameter solid bars set at 75mm centres. Sizes: 1170mm long x 700mm high
Extras
Anti Weaving Grids from £35 each
Hay Racks – Wall & Corner from £30 each |
